FEC Handheld Nutrunner HFC3000, Instruction Manual

Page: 88 / 231

Chapter 6 Fastening Operation
PAGE 6-18
In the Parameter
selection mode, “SYS.” is displayed in the WORK Display in the case of a SYSTEM
parameter and the parameter No. (P.01 to P.64) is indicated in the case of a FASTENING parameter.
The WORK Display is changed by pressing the
[►] or [◄] button and the content of the data No. is
indicated in the upper display section accordingly.
When the [▲] button is pressed the value in the WORK Display is increased by 1.
W
hen the [▼] button is pressed the value in the WORK Display is decreased by 1.
The current cursor (blinking)
position can be moved by pressing the [►] or [◄] button and, by holding
down
the [▲] or [▼] button, the value in the WORK Display can skip by 5 at a time (or the value in the
WORK Display can be skipped by 10 at a time).
Please refer
to the “List of Parameters” regarding the detail of the setting values.
“WORK” “COUNT/D-No.” “DATA”
Torque controller
Software Version
Amplifier Version
Touch Panel
Number of Retries
Fastening Method
Fastening Steps
Fastening Option
Unused
～
0 0 1
0 0 0
～
P 0 1
0 0 2
～
5 0 4
S Y S
0 0 1
0 0 0
0 0 2
5 9 9
P 6 4
[
▲] or [▼] button
WORK Display: skip 5 at a time while holding down
COUNT/D-No. Display
:
skip 10 at a time while
holding down