Fayat Group Dynapac CP2100, Instruction Manual

Page: 74 / 130

Transport
68 4812314580EN 2020-01-06
Transport
Preparing the roller for transport
Apply the parking brake and make sure the machine is in the
neutral position, that is, that the tires are pointing forwards.
Chock (1) the tires in an angle of 37º and at a minimum height
of 9,9 inches (25 cm). They should be chocked both forwards
and backwards.
Chock under the frame (2) to ensure that the chains remain
tensioned if the air goes out of the tires. Block up the machine
according to the figure.
Secure the roller with chains in all four corners. The
attachment points are shown in the safety decals. Put the
chains in symmetrical pairs, crossing each other.
Make sure the chains, supports and attachments of
the transport vehicle are approved and have the
proper tension to perform the fitting and locking.
Check regularly if the chains are not slack.
Fig. - Positioning
1. Chocks
2. Supports
3. Straps
2 2
3 3
3
3
1
1