Fayat Group Dynapac CP2100, Instruction Manual

Page: 51 / 130

Operation - Before starting
2020-01-06 4812314580EN 45
Operation - Before starting
Daily maintenance
Before starting your work shift and operating
the equipment, make sure the daily
maintenance was carried out. For further
information, refer to the maintenance section in
this manual.
Master switch
Check if the master switch is on. The master switch is located
in the electric device compartment (1) on the right side of the
machine.
If the main battery switch is closed, the engine
hood shall be opened during the operation to
make it possible to reach in an emergency.
The control and operation unit
The control and operation unit has three adjustment options:
transverse travel, rotation and steering column angle.
For transverse travel, raise the inner lever (1). The transverse
travel brake will be released.
For rotation, raise the outer lever (2). Make sure the control
unit is in the correct position before operating the machine.
For steering column angle, release the locking lever (3). Fix it
again in the new position.
To adjust the operator's seat, refer to the next section.
Perform all the control and operation unit
adjustments when the machine is stationary.
Before starting your work shift and operating
the machine, make sure the seat and the
steering column are locked and never release
the side travel if you are on a slope.
After the daily use of the roller, the master switch
shall be turned off. It prevents the machine to be
turned on accidentally and protects the electronic
devices.
1
Fig. – Engine compartment.
1. Battery switch
1
3
Fig. - The control and operation unit
1. Locking lever – transverse travel
2. Locking lever - rotation
3. Locking lever - steering column angle
2