Fayat Group Dynapac CP2100, Instruction Manual

Page: 58 / 130

Operation
52 4812314580EN 2020-01-06
Edge cutter (option)
To activate the edge cutter, the machine must be in low speed.
When the side panel button (1) is pressed with the machine in
low speed, a hydraulic piston lowers down the edge cutter to
the ground.
The tool can also be lifted if the machine is in the transport
position.
A bypass valve prevents the hydraulic system being
overloaded.
To prevent asphalt sticking to the edge cutter, the operator
shall use a separate sprinkler system. It is operated by a switch
(2). The water is supplied on the main tank and it is the same
used in the standard sprinkler system.
Tire pressure adjustment (option)
The operator can vary the pressure during the operation with
the tire air pressure control. It can be variable adjusted with the
keys (2) and (3) on the keypad, within the interval from 240
kPa to 830 kPa (35 to 120 PSI) and can be reduced with the
key (3). The tire pressure level is shown in the lower left corner,
on the Display (1).
When the tire pressure is at the maximum level
(830 kPa) or at the minimum level (240 kPa), it will
not be possible to increase/decrease the pressure.
Fig.– Side panel
1. Edge cutter, up and down
2. Edge cutter, sprinkler
Fig.– Side panel
1. Display
2. Increase in the tire pressure
3. Decrease in the tire pressure
1
2
3