FARMSCAN Jackal, Manual, Page: 7 / 52

AM-JACKAL-35 / JULY 2020 5
REAR CONNECTIONS (CONTROL VERSION & SPRAY)
The Jackal Spray Controller harness comes pre-terminated for ease of install and convenience.
The following table outlines the pre-termination of this cable.
A BOTTOM ROW (GREEN PLUG) B TOP ROW (GREY PLUG)
A1 INPUT 1 / NOT USED B1 GROUND / GPS PIN 5
A2 INPUT 2 / FLOW SENSOR
B2 INPUT 7 / NOT USED
A3 INPUT 3 / TANK LEVEL SENSOR B3 INPUT 8 / NOT USED
A4 INPUT 4 / WHEEL SENSOR B4 INPUT 9 / NOT USED
A5 INPUT 5 / NOT USED B5 +12v OUT / COMMON SENSOR POWER
A6 INPUT 6 / PRESSURE SENSOR B6 OUT 6 / DUMP VALVE
A7 COMMON SENSOR GROUND B7 OUT 5 / SECTION 3
A8 OUT 2 / MASTER MOTOR - B8 OUT 4 / SECTION 2
A9 OUT 1 / MASTER MOTOR + B9 OUT 3 / SECTION 1
A10 +12v IN / +12V BATTERY B10 RS232 TX
A11 -Ve IN / BATTERY GROUND B11 RS232 RX
Notes as below:
• The Jackal sprayer harness is wired to suit the Farmscan control valve bank (see below)
•
The Jackal Harness comes pre-terminated with Packard plugs & Pins
o
Adapter cables maybe purchased or included with some kits (Page7)
•
This cable can be modified for different valve bank assemblies.
•
Please refer to your implement supplier or auto electrician to determine the current requirement and wiring
if you are not using a Farmscan control valve bank.
•
The Jackal controller should only be connected directly to 3-wire motorised valves.
•
If you are connecting to a 2 Wire section valve (E.g., Arag or Hardi) you will require a 2-3 Wire Converter
(Farmscan Part Number A-2091) These are available to order at an additional cost.
Example – Farmscan 3 Section Valve Bank
(Farmscan Part Number AA-AF-CONTROL/3 or /3-D with Dump)