AM-JACKAL-35/ JULY 2020
10
THREE WIRE “ANALOGUE/VOLTAGE” – PRESSURE SENSOR OR DEPTH SENSOR
KIT # AA-114, AA-119-H, AA-119-L, AA-430
These kits will all include an “analogue” type of sensor. The
analogue sensor is 3 wire and uses a ground/earth wire, a signal
wire and a 12v power wire.
Typical sensors would include Pressure & Depth.
The diagram to the right shows which terminals to connect your
sensors to.
Insert the ground wire to either
(A7 or B1)
and the sensor wire into
(A6 or B2)
and the power wire to
(B5)
Use the generic wizard to setup the port and calibrate a sensor
once installed.
NB: The AA-430 (Depth Sensor) is powered by 5v – Please contact us to discuss powering options via the Outputs
Menu
THREE WIRE “BIN/TANK LEVEL”
KIT # 2060, A-2220P, A-2221
These kits will all include an “on/off, high/low, empty/full” type of
sensor. The analogue sensor is 3 wire and uses a ground/earth wire,
a signal wire and a 12v power wire.
The diagram to the right shows which terminals to connect your
sensors to.
Insert the ground wire to either
(A7 or B1)
and the sensor wire into
any
(A1-A5 or B3-B4)
and the power wire to
(B5)
Use the generic wizard to setup the port and calibrate a sensor
once installed.
GPS
KIT #T-135
GPS units supplied from Farmscan are pre-programmed and
ready to use with the Jackal Monitor.
The diagram to the right shows which terminals to connect your
GPS to.
Insert the black or green wire to
(B1)
and the white or yellow
wire into
(B11)
and the red wire into
(B5)
Use the wizard to setup the port and calibrate once installed.
NB: If you BYO GPS please ensure: GGA, VTG, RMC, 5Hz and a
baud rate over 19200kbps.
Summary of Contents for Jackal
Page 1: ...JULY 2020 For Serial Numbers 7000 9999 ...
Page 51: ......