FARMSCAN Jackal, Manual, Page: 19 / 52

AM-JACKAL-35 / JULY 2020 17
Using the NAV buttons
select how you would like
the UOD to be displayed on
the front screen.
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required. Press NEXT
Change the input name if you
desire, Press EDIT,
or Press NEXT
Select WHEEL or GPS to
setup the speed input. This
depends on the speed
option you have purchased.
For Wheel:
Refer to Page 21 to 23
For GPS:
Refer to Page 24
The Jackal has the ability to
have Preset Rates across the
bottom of the screen.
Example 50l/ha, 60l/ha etc.
The Step rate allows you to
easily up the rate by this
amount quickly from the
front screen.
Press NEXT
Press EDIT and change the
number of sections required
to control.
Press NEXT
Using the NAV & EDIT keys,
highlight and edit the
section width values as
required. The Section
Widths will also Total and be
displayed. Press NEXT
Using the NAV & EDIT keys,
highlight and edit the “Quick
set Rates” & Quick rate Step
Value.
Press NEXT
Using the NAV & EDIT keys,
highlight and edit the HOLD
& STOP values as described
below
Press NEXT
•
The Slow Hold Speed function is used to avoid
loss of spray coverage caused by loss of pressure
when travelling too slow or when reducing the target
rate below the recommended minimum for the
nozzles.
•
If the implement is travelling below this speed
(but above the minimum speed) then flow control is
regulated as if the implement were travelling at the
Slow Hold Speed.
• NOTE: Slow Hold is an optional function that can be set to operate at a minimum
speed equivalent to the minimum recommended pressure for a given target rate
(speed-based).
•
STOP : Will simply put the Jackal on hold at a set speed.
Change the input name if
you desire, Press EDIT,
Press NEXT
If you wish to setup a Tank
Level Sensor please refer to
PAGE 36.
If not, Press SKIP
Press NEXT to finalise the
Wizard and return to the
front screen
THIS ENDS THE AUTO
SET WIZARD SETUP FOR
SPRAYER SETUP