FARMSCAN Jackal, Manual, Page: 26 / 52

AM-JACKAL-35/ JULY 2020 24
AREA & SPEED METER USING GPS SETUP (WIZARD)
The Jackal can display Speed & Area in any combination of km/Ha or mph/acre.
A wheel sensor is not required when using a GPS. GPS purchased from Farmscan are
pre-programmed. If you BYO please ensure the following:
•
GPS programmed with RMC – GGA - VTG NMEA messages.
•
Any Baud Rate of - 4800,9600,19200,38400,115200 @ 5hz minimum.
Available Connections: Refer to Installing Sensors from PAGES 9-11
SETUP
From the front screen press
SETUP
Highlight WIZARD and press
SELECT
Highlight AREA/SPEED GPS
and press NEXT
Press the EDIT button to
change the baud rate, when
the correct baud rate is
selected the corresponding
NMEA message will be
acknowledged with a Y.
Press NEXT
Using the NAV buttons and
pressing EDIT enter your
implement width in (m). e.g.
12m
Press NEXT
Using the NAV buttons select
how you would like the area
to be displayed on the front
screen.
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required. Press NEXT
Name the input if you desire,
Press EDIT . e.g. SPEED
Press NEXT
Select either YES or NO to
display Speed on the front
screen with the area covered.
Change the input name if you
desire, Press EDIT ,
Press NEXT
Press NEXT to finalise the
Wizard and return to the
front screen
THIS ENDS THE
SETUP FOR SPEED/AREA
METER USING
GPS INPUT