FARMSCAN Jackal, Manual, Page: 24 / 52

AM-JACKAL-35/ JULY 2020 22
CALIBRATION (AUTO SET)
1. Ensure that the sensor and pickup are end-end before continuing
2. Mark bottom centre of tyre on which the sensor is fitted and peg ground in corresponding position
3. Measure out a known distance to calibrate i.e. 20m-100m
4. Peg the corresponding point i.e. at the 20/100m mark
Select TARGET
Select EDIT
Using the NAV buttons enter
your measured distance. i.e.
20.0000
Press EXIT when done.
Press START and move
forward slowly.
This will allow pulses to
register.
When you arrive at the
center mark point of tyre to
peg press STOP
Press CALC. This will divide
the distance travelled by the
number of pules registered.
MANUAL RATIO will now be
updated to reflect the
calibration factor.
Press NEXT
Using the NAV buttons and
pressing
EDIT
enter your
implement width in (m). e.g.
12m
Press NEXT
Using the NAV buttons
select how you would like
the area to be displayed on
the front screen.
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required. Press NEXT
Change the input name if you
desire, Press EDIT,
Press NEXT
Select either YES or NO to
display Speed on the front
screen with the area covered.
Change the input name if
you desire, Press EDIT
Press NEXT
Press NEXT to finalise the
Wizard and return to the
front screen
THIS ENDS THE AUTO SET WIZARD SETUP FOR SPEED/AREA METER