FARMSCAN Jackal, Manual, Page: 3 / 52

AM-JACKAL-35 / JULY 2020 1
GENERAL DESCRIPTION
Your new Farmscan Jackal Spray Controller or Monitor system is the result of extensive infield development
and will give many years of dependable service. Software & hardware updates are provided by Smart Ag
Systems Pty Ltd.
3 Section Spray Controller (Controller Unlock)
Once installed and calibrated, the system will automatically maintain the selected spray rate regardless of
speed or pressure variations within the limits of the sprayer pump capacity and nozzle size.
This version of the Jackal is completely unlocked, un-restricted and has the full feature set of the Jackal-
Monitor. NB: Inputs consist of 7x Pulse & 2x Varying Inputs. Simply add additional sensors to utilise the
Jackal to its full potential.
Our onboard calibration wizard makes setup a breeze! It’s simplified with the ability to enter either a factor
(pulses per unit) or simply drive/run a set amount whilst the unit is counting the pulses and let the system
calculate its own factor.
24 recordable trips allow the operator to track numerous jobs in a period of work and each input can be
used to display information using imperial and metric units.
TECHNICAL SPECIFICATIONS
Specifications below are subject to change and are based on a fully unlocked Jackal.
Power Requirements (12Vdc) 10 – 18 VDC @ 250mA
Display 128 x 64 Mono Graphic LCD
Operating Temperature 0 to 50
˚
c
Storage Temperature -5 to 65 ˚ c
Dimensions 135mm H x 100mm W x 30mm D
Sensor Inputs 9
Inputs 1-5 & 8-9 (Square Wave) Up to 400 pulses per second (On/Off/Freq)
Inputs 6-7 Analog Voltage 0 – 5V
GPS RS232 TX/RX
Ground 2
Output PWM 2
12v 1
Output 4
Output current rating 4A/output
DISCLAIMER
The warranty offered on this Farmscan product is limited to the repair or replacement of the faulty goods.
No liability will be accepted for loss of profit or productivity.
WARRANTY IS VOID if power and or sensors are
not connected as described in this guide.