Lumina 35
Inputs and outputs
51
When controls are assigned, the I/O settings are filled in automatically. When Fancom equipment is
used these settings will normally ensure correct control. These settings can be adjusted using the zoom
function (
).
The input and output settings can be readout, and changed in the INPUT / OUTPUT menu. However,
we advise you not to make changes here but to do these changes in the setup screens.
There are four different connections:
•
Digital input: shows the
status
of a certain object
•
Digital output( relay):
control
a process, by activating or deactivating this output
•
Analog input:
readout
of a certain value (for example house temperature)
•
Analog output:
controls
a process at a certain value (for example fan at 40%)
The sections below explain the setting possibilities per type or input or output.
The address of the chosen connection must be entered at various places in the system settings.
An input or output address consists of two parts, separated by a decimal point: NN.MM
The first part (NN) is the hardware address:
•
For connections to the internal hardware (IOB): NN = 0
•
For connection to an external help card (I/O-net number): NN = 1
– 31
The second part (MM) is the sequence number of the specific connection: MM = 1
– 99. For internal connections
the sequence number is shown in Interior control computer page 55.
The following measurements can be calibrated:
•
Pressure
•
RH
•
CO2/NH3
•
Temperature
•
Wind direction
In the corresponding zoom windows set the values
HIGH
and
LOW
using the actual measurement value.
Use the softkey to select the wizard to calibrate the values:
•
Calibrate LOW Zero
: Setting of the zero value for the measurement. At this input value the measurement is
minimum.
•
Calibrate HIGH Span
: Setting of the span value for the measurement. At this input value the measurement is
maximum.
Summary of Contents for Lumina 35
Page 1: ...g...
