Lumina 35
Installer
39
Pre-run time
Setting of the time in which the air inlets go to the required position, before the fans
activate.
Link modulation
Setting indicating if these air inlets are to be included in modulating ventilation
— if
modulating ventilation is used.
Position wind side
Setting of the compass positions, which represent the wind side of the house. If the
wind comes from this direction (positions), the ventilation control may be influenced.
Position lee side
Setting of the compass positions, which represent the lee side of the house. If the wind
comes from this direction (positions) under wind side, the ventilation control may be
influenced.
INSTALLER
→
VENTILATION
→
INLETS
→
tab page
Nat.
Description
Setting of the name of the function.
Temp. inputs
Setting of the addresses of the temperature inputs.
Output address
Setting of the analog output address.
Analog type
Setting indicating the analog control type
During mech.vent.
Setting if the air inlet is open or closed during this phase.
•
FOLLOW COMBI
: according to the percentage in the combi-table (normal setting).
•
CLOSED
: close (the curtain at the side of house where the fans are placed must be
closed during mechanical ventilation).
•
CLOSED UNTIL
: close until a certain combi step, from this step the inlet will follow
the combi-table.
During nat.vent
Setting indicating if the extra inlets have to be open or closed during natural ventilation.
•
CLOSED
: close (normal setting)
•
FOLLOW NAT.
: if this air inlet must follow the natural curtain (e.g. tunnel curtains
which also have to open during natural ventilation).
Pre-run time
Setting of the time in which the air inlets go to the required position, before the fans
activate.
Position wind side
Setting of the compass positions, which represent the wind side of the house. If the
wind comes from this direction (positions), the ventilation control may be influenced.
Summary of Contents for Lumina 35
Page 1: ...g...
