Lumina 35
Installing the Lumina 35
20
Connect the Lumina 35 as follows:
1. Open the cover.
2. Connect the Lumina 35 to the manual switch.
3. Connect the manual switch to the main supply (be sure power is disconnected).
4. Connect other (signal wires) to the Lumina 35, see chapter Technical specifications.
5. Close the cover.
Always use the cable gland when connecting the Lumina 35. Use the sealing discs supplied to seal off
any unused cable glands. Use a sealant to seal all cable glands, after the computer has been
connected, to prevent the entry of moisture, dust and/or aggressive gasses.
Check that the mains voltage and frequency, for which this Fancom controller is suitable (see chapter
Technical Specifications in this manual), correspond to the mains voltage and frequency on site.
Be sure that the Lumina 35 is properly grounded. When using metal cable trays, grounding at one point
of the tray is recommended.
The Lumina 35 should be possible to shut down with a suitable double pole switch which is easily
accessible.
Connect the Lumina 35 to a group (16A) from the main distributor and mount the cables in separate
cable trays.
Limit the length of the signal wires much as possible; avoid crossing high/low voltage wires.
To protect against lightning, place an over voltage protection device in the power supply of the Lumina
35.
Condensation should never occur in the controller.
Summary of Contents for Lumina 35
Page 1: ...g...
