Fagor 8025 M CNC, Translation Of The Original Manual

Page: 171 / 180

Remote modules.
CNC 8060
CNC 8065
CAN BUS (CANFAGOR/CANOPEN
PR
OTOCOLS).
8.
Sele
ctin
g th
e
b
aud
ra
te
for th
e CANope
n bus.
·171·
(R
EF
: 1906)
to dipswitch ·4·. The first time the module is configured, the TX LED blinks indicating that
no valid speed has been selected.
The first 4 dipswitches are used to select the speed; the rest must be in the ·off· position.
To select the speed, put the corresponding dipswitches in the ·on· position.
To save the selected speed, put dipswitch ·8· in the ·on· position. After saving the
configuration, the corresponding LED's turn on to indicate the module speed. For 1 MHz,
all four LED's turn on.
Once the speed has been selected, turn the module off by removing power and set dip-switch
·8· in the ·off· position. Bear in mind that the next time the module is turned on, the position
of the dipswitches will indicate the address (node number) of the group.
If when turning the module on, all the dipswitches are not in the ·off· position, the position of the
dipswitches will be the new address (node number) of the group.
i
Dipswitch ·1· Dipswitch ·2· Dipswitch ·3· Dipswitch ·4· Speed
Off Off Off Off 1000 kHz
ON Off Off Off 800 kHz
Off ON Off Off 500 kHz
ON ON Off Off 250 kHz