Fagor 8025 M CNC, Translation Of The Original Manual

Page: 161 / 180

Remote modules.
CNC 8060
CNC 8065
RCS-S-4F4
AO (SERCOS-II
PROTOCOL).
7.
Software install
ation/up
date.
·161·
(R
EF
: 1906)
7.11 Software installation/update.
Requirements for updating the software.
The software for the RCS-S (Sercos counter) module can only be installed or updated
through Fagor’s WinDDSSetup application for PCs (version 08.06 or later). In addition to
having this application installed on the PC, the RCS-S module must be connected to the PC
by a RS-232 series line cable.
Process to install or update the software.
3 If the "Online" option is shown, uncheck it to enable the "Boot" option. Its associated icon
will also be enabled on the tool bar.
BOOT.
Proceed as follows:
1 Run the WinDDSSetup application at the PC.
2 Display the top menu "Work mode" and mark the option "Boot".
4 Click on the "Boot" icon of the tool bar to access the "BootType" window.
5 Select "BOOT_RCS_S" from the list and click on "Validate". That will display the
"BootStrap" window.