Factory Five Racing Type 65 Coupe, Assembly Manual

Page: 32 / 442

31
www.factoryfive.com 508-291-3443
Remove the steering column mounts located under the dash above the driver floor. Allow the column to
fall down.
Remove the wiring connectors have from the turn signal and ignition switches.
Remove the turn signal stalk
Dash Wiring Harness

Socket set, extension, regular, Torx and Phillips head screwdrivers, needle nose pliers, hammer,
and marker tape.

Dash wiring harnesses

The wiring comes out in stages. Keep the sub-assemblies together as they are removed.
Remember to identify both ends of every connector that you disassemble. The easy way to do
this is to tape and number each side of the connector the same or use colored zip ties. The
connectors will only work if they’re mated to the other similar shaped connector. Almost every
connector is different in the car, so cross wiring is rare. Labeling will help speed up the job later.
Remove the dash from the car.
Remove the wiring harness and all of the “black boxes” hooked into it from the dash. Mark all of the
connectors to prevent any confusion later.
Disconnect the connectors from the headlights and engine harnesses marking each connector with what
it connects to.

The headlight dimmer switch should be kept if dash lights are wanted otherwise the switch will
have to be bypassed.
87-93 Dash harness with air bag and fuse panel attachments.