INSTRUCTION MANUAL DAAB AUTOMATIC CONTROL UNIT EP105
9
Revision 3
Description of the EP105
• General
The EP105 is an automatic control unit for doors, gates, up-and-over doors and barriers, including all the components
necessary to control electric motors – contactors, motor protection, load guards, safety edges, alarm indications, buttons on
the PCB for operation and display, and a programming keypad.
The control unit can be supplied with accessories such as a vehicle loop, wireless functionality, signal lights and magnetic locks.
• Intended use
The purpose of the automatic control unit is to open and close doors, gates, up-and-over doors and barriers, using controllers
connected to the unit.
No other use is permitted without the written agreement of FAAC Nordic AB.
• Identification
• Reference documentation
Instruction manual for drive unit
Instruction manual for the door, gate or barrier
• Disposal of electronic equipment
!
The EP105 is an electronic product, and as such is classified as hazardous waste. All used electronic equipment must
be sent for recycling by a company authorised under environmental legislation to handle hazardous waste including
electronic equipment. FAAC Nordic AB will not charge to process used electronic products supplied by us, provided they
are returned to us.
• Instruction manual
This instruction manual, or an instruction manual that fully complies with the requirements of the applicable Machinery
Directive and Low Voltage Directive and related relevant harmonised standards, must be provided with the finished control
unit to the installer and the end user.
Connector for software
upgrade.
Display
Data entry and
readout buttons
Indications
Control buttons
Terminal block
for low current
Indications
Motor contactors
Terminal block
for high current