■
Graph screen
■
Control mode select screen
-23-
■
Graph screen
※
When the vapor temperature
sensor is connected
■
Control mode select screen
Vapor temperature
display
Measured pressure
Leak
Menu
Run
Stop
Power
Hold
MANUAL
00:04:46
Display
Set Press
hPa
200
Leak
Menu
Run
Stop
Power
356
1000
0
15
min
Hold
Leak
Menu
Run
Stop
Power
Mode
MANUAL
00:04:46
Display
Set Press
hPa
200
Leak
Menu
Run
Stop
Power
200
1000
0
15
min
Run
Vapor 20.8
℃
50
℃
Leak
Menu
Run
Stop
Power
Mode
MANUAL
Cleaning
00:00:00
Display
932
hPa
Set Press
hPa
200
Leak
Menu
Run
Stop
Power
Leak
Menu
Run
Stop
Power
MANUAL
Standby
00:00:00
Esc
1013
hPa
Set Press
hPa
200
Leak
Menu
Run
Stop
Power
(1) "Hold" function
If you press the [Hold] key during decompression or
slope control during operation, the pressure at the time
you pressed the key will be maintained.
* This function is useful to avoid bubbling or
sudden boiling, pause condensation or change
the set pressure.
Press the [Hold] key again to release this
function.
(2) Manual "Cleaning" function
If you keep the leak key pressed for more than three
seconds during standby, the unit enters the manual
cleaning mode and purges solvent remaining in the
vacuum pump, the control solenoid valve or pipes to
outside the unit.
* The manual cleaning will finish automatically in
about three minutes (initial setting) and you must
not forcibly end in the middle of it.
* For set time of manual cleaning, see "Parameter
setting" on P. 36.
【
Caution
】
You cannot perform manual cleaning while two
vacuum control assemblies are in the mutual
communication control and one of them is in
operation.
(3) Graph display function
You can use the [Display] key on the control mode
select screen to display a graph during operation. You
can check pressure trend on a graph including
decompression status (slope and a fixed-value), status
using the hold function by setting the operation start as 0
minute. The time scale will change depending on the
operation time as follows:
15min→30min→60min→90min.
* When the operation time has exceeded 90
minutes, only the graph will be scroll-displayed.
(You can check on the graph pressure changes
up to 90 minutes before.)
Functions common to the all modes.
(4) Vapor temperature display function
You can measure vapor temperature during
condensation by connecting a vapor temperature
sensor (optional).
Vapor temperatures will be displayed on the control
mode setting screen, the setting screen, and the graph
screen.
(5) Canceling operation being set [Esc] function
You can press the [Esc] key during setting to cancel the
setting operation and return to the original setting.
