Operation, cont’d
Digital XPoint Matrix Switchers • Operation
3-8
Example 3: Remove a tie from a set of ties
The following steps show an example in which an existing tie is removed from the
current configuration in enter switch mode. Each step shows the front panel
indications that result from your action.
This example assumes that the switcher is in enter switch mode. If the
switcher is in the quick switch mode, output buttons light red and the step in
which the Enter button is pressed is not necessary.
1
.
Press and release the input 5 button (figure 3-13). If the steps in Example 1
have been completed, the output 1, the output 3, output 4, and output 8
buttons indicate ties already created.
INPUTS
1 2 3 4 5 6 7
8
OUTPUTS
1 2 3 4 5 6 7
8
INPUTS
OUTPUTS
N o S y n c
I n p u
4
t
# 5
_ 5 5 _ _ _ 5
5
1 2 3
5 6 7 8
Press and release the input 5 button.
The button lights
green
.
The LCD displays the input
'
s status (Detected or
No Sync), then the current s
w
itch configuration.
See
Viewing source status and the current
configuration
in this chapter.
1 Second
Buttons for selected outputs light
green
.
Figure 3-13 — Select an input
2
.
Press and release the output 4 button (figure 3-14). The output 4 button
returns to either unlit or to background illumination, while the output 1,
output 3, and output 8 buttons remain lit green. The Enter button blinks to
indicate that a potential change to the configuration needs to be confirmed.
Press and release the output 4
button. The button goes out or
returns to background illumination.
The Enter button
blinks
green
to
indicate the need to
confirm the change.
OUTPUTS
1 2 3 4 5 6 7
8
CONTROL
ENTER
PRESET
Buttons are
green
to indicate current ties.
= Blinking Button
Figure 3-14 — Deselect an input
3
.
Press and release the Enter button (figure 3-15). The input, output, and Enter
buttons return to either unlit or to background illumination. The LCD returns
to the default display. The current configuration is now defined as input 5
tied to output 1, output 3, and output 8.
Press the Enter
bu
tton to
confirm the config
u
ration
change.
CONTROL
ENTER
PRESET
STATUS
D X P
8 8
E X T RON
The LCD ret
u
rns to the
defa
u
lt display.
All
bu
ttons ret
u
rn to
u
nlit or
b
ackgro
u
nd ill
u
mination.
Figure 3-15 — Press Enter
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
