Installation, cont’d
Digital XPoint Matrix Switchers
•
Installation
2-2
Installation
Mounting the Switcher
The Digital XPoint Matrix Switcher comes with two sets of mounting brackets. One
set is for mounting the switcher under a table or against a wall, and the other set is
for rack mounting.
Table or wall mounting
The table/wall mounting brackets extend approximately 1/4” (6.4 mm) above the
top surface of the switcher enclosure. This design allows for an air space between
the enclosure and the surface to which it is mounted. Table or wall mount the
switcher as follows:
1
.
Attach the table/wall mounting brackets to the switcher with the eight
provided #8 machine screws (figure 2-1).
2
.
Hold the switcher with the attached brackets against the underside of the
table or other furniture, or against the wall. Mark the location of the
screw holes of the bracket on the mounting surface.
3
.
Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.4 mm) deep in the
mounting surface at the marked screw locations.
4
.
Insert #8 wood screws into the four pilot holes. Tighten each screw into
the mounting surface until just less than 1/4” of the screw protrudes.
5
.
Align the mounting screws with the slots in the brackets and place the
switcher against the surface, with the screws through the bracket slots.
6
.
Slide the switcher slightly forward or back, then tighten all four screws to
secure the switcher in place.
Rack mounting
Rack mount the switcher as follows:
1
.
Attach the rack mounting brackets to the switcher with the eight
provided #8 machine screws (figure 2-1).
1.5
A
MA
X
10
0-2
40
V
5
0-6
0H
z
INP
UTS
1
2
3
4
5
6
7
8
OUTPUTS
1
2
3
4
5
6
7
8
EX
T.
RE
F.
IN
RS
23
2/4
22
OU
T
#8 Screw (4 Places)
Each Side
Mounting Screws (2 Plcs)
Each Side
or
Rack-mounting
Bracket
Table/
Wall-mounting
Bracket
Drill pilot holes —
3/32” (2.4 mm) diam.
1/4” (6.4 mm) deep.
Figure 2-1 — Mounting the Digital XPoint Switcher
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
