EVS XSnano, Configuration Manual

Page: 62 / 198

Editing Commands
The following table presents the commands to edit a setting in the Setup menus of the
Remote Panel:
Command description Command key
Selecting a setting in a section F_ key corresponding to
the requested setting
Modifying the setting value Turn the jog wheel
Validating the modification to a setting value ENTER
Restoring the default value for the selected setting CLEAR + F_ key
corresponding to the
requested setting
Restoring the default values on the entire Setup menu CLEAR + F0
Validating the changes in the Setup menu
(to answer to the message when you try to leave the menu) MENU
Cancelling the changes in the Setup menu
(to answer to the message when you try to leave the menu) CLEAR
Staying in the Setup menu
(to answer to the message when you try to leave the menu) ENTER
3.1.6. Required Application Reboot
Introduction
Modifications to some parameters will only be applied after rebooting the application.
When you change one of the following parameters, a message will inform you that you
need to reboot Multicam.
Such parameters are summarized below, but the parameter description also specifies
when a reboot is required:
Tab Name Setting Name
Server tab Some video and reference settings:
• Field rate
• Resolution
• LTC timecode
Server tab All codec settings
Warning
When you change the codec essences active on the EVS
server, you may be required to clear the video disks. See
section "Clearing Video Disks" on page 40
52 3. Multicam Configuration
EVS Broadcast Equipment SA Issue 12.02.C - April 2014