Installation and connection
Doc. no. BA012498_03
33 / 112
GB
The following shows an example of a correct connection:
DALI C0
RJ-45
RJ-11 ELC-Bus
OFF
1
ON
2
3
1
1
ON
2
Correct connection using the ELC bus:
1: Lighting groups
2: ELC bus configuration switch for devices at the start and end of the con
-
nection. Switch position: ON.
3: ELC bus configuration switch for devices in the middle of the connection.
Switch position: OFF.
4.5 Warm-up phase
The Light Control Box starts the warm-up phase each time the power is
switched on.
Configuring the Light Control Box during the warm-up phase:
• Connected lights are on.
• Connected presence detector: During this phase, first the red LED
flashes, then the blue LED flashes. Finally, the green LED flashes four
times, after which point the detector is ready for use.
