The remote control menu <Programming>
Doc. no. BA012498_03
52 / 112
GB
8
The remote control menu <Programming>
In the <Programming> menu item, you can set permanent settings.
The settings are retained even when the device is not supplied
with power — for example because the power supply in the build-
ing is switched off overnight.
8.1 Activate/deactivate programming mode
To activate programming mode, proceed as follows:
Press the
button.
The blue LED on the presence detector lights up.
The lighting is switched to 100% luminous efficiency.
The red LED on the detector flashes twice to confirm each re-
ceived command.
To exit programming mode, proceed as follows:
Prerequisites:
• The blue LED illuminates in the sensor head.
Press the
button.
Your settings are saved and programming mode is closed.
The blue LED goes out and the Light Control Box switches the
lighting off.
If programming mode is not ended via the key button within five
minutes of the last entry, the Light Control Box automatically
switches back to normal operation mode. The settings are auto-
matically saved.
8.2 Calibration
The
Calibration
function can be used when lights with in-built light sensors
are connected to the Light Control Box. The light sensor is affected by light
from reflective work surfaces, walls and floors. Calibration is essential for
ensuring that surfaces at a specific height remain evenly lit.
A lux meter is required for calibration. The light values measured with the
lux meter can be transferred to the Light Control Box by remote control. The
measured lux values are reference values used by the Light Control Box for
precise comparisons. The calibration allows the Light Control Box to calcu-
late more precisely which illumination level is required to retain a constant
target brightness.
Only lights with
light sensor
Lux meter
