Esko Kongsberg XP, User Manual

Page: 90 / 218

12
Kongsberg XP
Tool Adjustment
For this tool, complete the following adjustments:
Adjustment Description
Lag Setting The nominal value for Perforation wheels is 0 mm.
Note : The Lag value can be used to adjust overshoot and Lead-in of
Perforation Cut Lines .
Tool Height
Measured automatically, as separate tool, possible to add an Offset Value .
Note : The height measurement of the Perforation Wheels depends on the
orientation of the wheel (pit or land facing measuring station). This becomes
more critical with bigger pits.
Tool Rotation Adjust Tool Angle tangential to Moving Direction .
Center Offset Adjust Tool sideways until centered.
Tool Offset Adjust offset relative to Laser Pointer .
Tip : When adjusting Tool Height for Perforation wheels or Crease wheels , move the tool outside of
the material surface. Set the Tool Height so that the Tool tip touches the Table Top Surface before
manually jogging the tool through the material. Complete wizard and inspect crease/perforation result
(should yield a good quality crease or perforate all the way through material).
For more information about how to run the
Adjustment Wizards , see the Tool Configuration section.
12.6.6. Bevel Knife 45
Bevel Knife is a special-purpose tool for 45 degree
angled cuts.
Lag = 3.5 mm / 0.14 in.
How to replace a Knife Blade
Warning: Sharp tool
90