12
Kongsberg XP
V-notch
Crease
This is the default mode if neither
V-notch cut
nor
Waste Cut
are enabled.
Performing two cuts in opposite direction to
create a folding notch.
Width Offset
Width Offset is used to adjust the width between
the two cut lines along and across flute when
Crease
is selected.
Waste Cut
Waste Cut
adds a third cut line to ease removal of
waste.
Note:
This function is working along Y only. Flute
direction must be along Y. The numbers indicate
sequence of operation.
Geometry
When the knife angle is 45
o
and you cut through
the material, the width of the cut is W = 2 x h.
Folding
If you prepare a material for folding, the following rules applies:
• Adjust the cutting depth to just above the bottom liner.
• Adjust the cutting width (W) by the adjustment parameter Width Offset. Nominally, the width of the
cut has to be increased by Width Offset = - 2 x bottom liner thickness.
84