7
Kongsberg X-series
The
Warning Lamp
on top of the Y carriage should be constantly lit. Any
malfuction of the lamp must be corrected as soon as possible since this is a
safety feature.
6
Table Zero Sequence
Press
Start
pushbutton to complete the
Table Zero Sequence
.
The machine will move to the
Selected Reference Point
.
7
Spindle Warm-up (milling toolhead only)
Run Warm-up sequence by pressing this button in iPC. The spindle warning
lamp (red) should flash shortly and then light constantly. This indicates that
the spindle rotates. Any malfunction of the lamp must be corrected as soon as
possible since the lamp is a safety feature.
8
The table is now ready for operation.
7.2. Reset Safety System
Press
Pause
to
Reset Safety System
.
7.3. Power Off Sequence
Follow these steps to power down the system:
1
Servo Power
Press the
Servo On
pushbutton to switch
Servo Off
.
2
Table Power
Turn
Table Power
off using the
Main Power Switch
.
Note: After power off, wait minimum 5 sec. before the system is switched on
again.
3
Front End PC
39
