12
Kongsberg X-series
Suction house, adjustable height
On MultiCUT-HP, you can lock the suction house in any height; still, it is allowed to move upwards.
This function is useful in order to
1.
Adapt to different material thicknesses.
2.
Allow false air input in order to reduce suction force.
Procedure:
1.
Loosen lock screw (a).
2.
Adjust suction house to desired height.
Spindle RPM limitations
Running 8 mm bits at a high RPM rate can generate vibrations and excessive wear.
Using
milling bits
with extended length at high RPM can also be dangerous.
Therefore, using long
milling bits
is subject to an automatic RPM reduction.
If you are using short 8 mm bit, these must be limited manually to 40.000 RPM.
In general, 6 mm bits are preferable in materials up to 20–25 mm thickness.
12.8.3. Cooling Water Connections
Note:
Small droplets of liquid could appear as the cooling water tubes are connected / disconnected.
This is normal behaviour.
Maximum liquid dripping is specified to be 0.77 cm3 at each removal.
Use a rag of textile to avoid this liquid reaching material / table top.
12.8.4. Safety issues
Unattended Operation
95
