12
Kongsberg X-series
Never use higher RPM than recommended by the
bit supplier.
Special care should be taken when using bits with
cutting diameter
larger than
shank diameter
.
Bits with small
cutting diameter
(3-4 mm;
0.12-0.16 in) are more balanced than bits with
larger
cutting diameter
Thus, they can run with higher RPM, normally
60.000.
Use large diameter bits (5-6 mm; 0.20-0,24 in)
when needed only.
Typical use is to get rid of the chips in thick
materials.
Max RPM (MultiCUT-HP) 60.000.
Milling bit
edges are brittle.
Never let bits touch each other, or other hard
surfaces.
Always store in proper container.
102
