12
Kongsberg X-series
Disable Material Thickness Measurement
Opened Job
->
Production Setup
->
Material Handling
For the
Foam Knife Tool
, the
Disable Material Thickness Measurement
function is available.
Use this function if
• Your foam material is too soft for the measuring system.
• The surface of your material is un-even.
When the
Disable Material Thickness Measurement
function is enabled, the following rules applies:
• Depth is referenced from bottom (top of cutting underlay).
• During
Tool Up
movements, the knife is lifted to its top position.
12.8. MultiCUT/MultiCUT-HP
Router Bits are extremely sharp!
12.8.1. Introduction
MultiCUT/MultiCUT-HP
MultiCUT/MultiCUT-HP are special purpose
tool heads
, which can be equipped as follows:
• Two general tool positions prepared for the standard
FlexiHead
tools.
• Milling tool equipped with a high speed milling spindle.
90
