19
Kongsberg X-series
3.
Push the round Safty disks outwards using 2 hands.
4.
With one person on each side, simultaneously lift the shaft straight upwards from the fixture.
19.6.2. Load material to the Autogrip Shaft
The use of a material lift is recommended when working with heavy rolls
Note
: Make sure the material is not fixed to the core.
1.
Insert the Autogrip Shaft in the material roll core (a 75 mm / 3 in. coil) and make sure it is centered.
The Autogrip Shaft uses rubber blocking cords to grip inside the material core. By rotating the
material roll slightly, the rubber will engage with the Autogrip-Shaft.
2.
The fixtures for the shaft can move independently. Check if both fixtures are still in the correct
position before lifting the Autogrip Shaft.
3.
Place the Autogrip Shaft back in the fixtures of the
Motorized Roll Feeder
and use both hands to
close them.
4.
Center shaft by pressing the Edge Control Centering button (E)
19.6.3. Feeding the material through the MRF onto the table
201
