20
Kongsberg X-series
The machine will not operate in any mode when control power is off.
20.8. Operator Controls
The operator controls are located on the controls
pedestal.
The operator control functions are described
below:
1 - Emergency Stop pushbuttons
The Emergency Stop pushbutton is pressed inward to cause the i-BF
emergency stop safety circuit to be de-energized causing the machine to be
in a safe condition.
The i-BF cannot be run in any mode of operation while any Emergency Stop pushbutton is pressed
inward, or when the emergency stop safety circuit is de-energized.
Once pressed, the Emergency Stop pushbutton is maintained in the inward position.
The button is reset to the outward position by twisting in a clockwise rotation as indicated by the
arrows on the button.
2 - Mode Manual/Auto Selector Switch
The Mode selector switch is used to put the i-BF into Auto or Manual mode of operation.
Auto Mode
In Auto Mode, the i-BF will respond to commands from the table.
In Auto Mode, the i-BF will transfer media from the stack to the support
table according to the parameters set through the Touch Screen.
Manual Mode
In Manual Mode, the i-BF will not respond to commands from the table.
Manual Mode is used to manually jog the i-BF gantry and carriage beam
using the Jog selector switch as enabled in the touch screen.
Manual Mode is also used to run single sequences, initiated by the touch
screen.
219
