ERL tesla lite, User Manual, Page: 74 / 288

7 Recorder Setup Utilities
7-14 TESLA LITE User Manual D03283R01.10
Table 7.5: Notify Settings
Connect Using The TESLA recorder can be set to notify a RecordBase Central Station
via modem or LAN, or to not notify at all. These 3 options are mutually
exclusive. Note that the availability of these controls is dependent on
the hardware options and configuration of the recorder.
Modem If Modem is selected, enter the telephone number of the RecordBase
call-in modem. All standard modem dialing characters are supported
(e.g. a comma is used to specify a pause in the dialing sequence).
LAN If LAN is selected, enter the IP address of the computer running
RecordBase Central Station.
Do Not Connect If Do Not Connect is selected, the TESLA recorder will not notify
RecordBase Central Station of new records or cross triggers. This is a
global setting and can be used to temporarily disable notification.
Retry Attempts These rules are applied when the TESLA recorder fails to establish
communication with RecordBase Central Station (i.e. if the phone line is
busy, or if the network is down).
Maximum
Attempts When the TESLA recorder fails to establish contact with RecordBase
central station, this is the maximum number of attempts it will make
before giving up.
Delay Between
Attempts Specifies the delay, in seconds, that the TESLA will wait before making
another notification attempt.
Notify on creation
of new Recording
if Priority is at
least
Controls which records, if any, are automatically transferred to the
RecordBase Central Station. When a record is created with a priority
equal to or greater than the specified value, the recorder sends a New
Record Created notification message to RecordBase.
The setting can range from 0 (all records) to 3 (highest priority only).
Selecting Do Not Notify disables automatic record transfers completely.
Record priority is determined by the highest priority trigger included in
the record. Trigger priority is set as part of each channel’s configuration.