ERL tesla lite, User Manual, Page: 37 / 288

4 Communicating with the Recorder
D03283R01.10 TESLA LITE User Manual 4-7
C:\WINDOWS\tiinst\TUSB3410
In the window
“Hardware Installation”
“The software you are installing for this hardware
“ERLPhase 4000 Series Device”
has not passed Windows Logo testing to verify its compatibility with
Windows XP or “Windows can’t verify the publisher”
Hit Continue Anyway
In the window
“Completing the Found New Hardware Wizard”
“The wizard has finished installing the software for”
“ERLPhase 4000 Series Device”
Hit Finish
To verify the installation was successful, and to which comm port is the
ERLPhase 4000 Series Device configured, do the following:
In Windows XP go to
Start>Control Panel>Performance and Maintenance>Sys-
tem>Hardware>Device Manager>Ports
or (if using Control Panel’s Classic View)
Start>Control Panel>System>Hardware>Device Manager>Ports
In Windows 7 ‘small icons’ view, go to
Start>Control Panel>Device Manager>Ports
Look for the port number associated to this device
“ERLPhase 4000 Series Device”
Look for a COM#, where “#” can be 1, 2, 3, etc. Leave the default
settings for this port.
It is recommended to restart the PC after the USB driver installation.
The default baud rate for the recorder USB Port 450 is 115200, however to
double check it login to the recorder display and go to:
Main Menu> System> Recorder Comm Setup
To establish a USB link between the recorder and your computer, connect
your computer’s USB port and Port 450 on the recorder’s front panel. Use a
standard USB peripheral cable.
1. Ensure the recorder port and your PC’s port have the same baud rate and
communication parameters.
• The recorder’s USB port appears as a serial port to the PC and is fixed
at 8 data bits, no parity and 1 stop bit and has a default baud rates of
115,200 bauds.
• The baud rate and communication parameters of your computer's USB
port is set automatically by TESLA Control Panel (Edit IED>Commu-
nication>Direct Serial Link )