The Iimage Quality of the Sent Fax is Poor
The following causes can be considered.
The Original Type setting is wrong.
Solutions
Select
Fax
>
Fax Settings
>
Scan Settings
>
Original Type
, and then change the setting. When the
original you are sending contains text and images, set this to
Photo
.
The resolution is set to low.
Solutions
If you do not know the performance of the sender’s fax machine, set the following before sending a fax.
❏
Select
Fax
>
Fax Settings
and then make the
Resolution
setting to set the highest quality image.
❏
Select
Fax
>
Fax Settings
and then enable
Direct Send
.
Note that if you set
Resolution
to
Super Fine
or
Ultra Fine
but you send the fax without enabling
Direct Send
, the fax may be sent at a lower resolution.
ECM setting is disabled.
Solutions
Select
Settings
>
General Settings
>
Fax Settings
>
Basic Settings
and enable the
ECM
setting on the
control panel. This may clear errors that occur due to connection problems. Note that the speed of
sending and receiving faxes may be slower than when
ECM
is disabled.
An Image of the Reverse Side of the Original Appears in the Sent Fax
The following causes can be considered.
When scanning thin originals, images on the back may be scanned at the same time.
Solutions
Place the original on the scanner glass and then place a piece of black paper over it.
&
“Placing Originals” on page 42
>
Printing, Copying, Scanning, and Faxing Quality is Poor
>
The Quality of the Sent Fax is Poor
298
