51
Printing the Amount of Media Remaining
After you print, you can print the amount of media remaining on the leading edge of the remaining roll.
This lets you enter the number the next time you load the media for the most accurate accounting of the
media remaining on each roll
Note:
You must have turned on the
Remaining Setup
setting on the product control panel to calculate
the amount of media remaining.
1.
Make sure your product is ready to print.
2.
Press the
media setup button, select
Media Remaining
in the displayed menu, and press the
OK
button.
3.
Select
Print Remaining Length
and press the
OK
button.
4.
Press the
OK
button to print the amount of media remaining.
Parent topic:
Removing Printed Media
Related references
Media Setup Menu Settings
Cutting Media
When you finish printing, use a commercially available cutter to cut the media.
Warning:
Be careful not to cut yourself when using cutters or other sharp blades. Also be careful
touching areas near the after heater since the after heater may be hot and you could be burned.
1.
Press the
media setup button.
Summary of Contents for SureColor S40600
