3-4
3-4
|
Maintaining and Transporting the Printer
If you’re using EPSON paper, leave this setting on
STD
.
If you’re using other media, enter the thickness value of the paper in
0.1-mm increments by pressing the
+
or
–
button.
4. Press the
Enter
button to save the setting.
ADJUST. PATT.= ALL
appears on the display.
5. Press the
Enter
button to print the full series of alignment patterns.
If you want to print a single alignment pattern, press the + or – button
until the pattern number appears. Then press the
Enter
button.
•
For the EPSON Stylus Pro 9500, skip to the next section,
“Completing the Alignment Procedure.”
•
For the EPSON Stylus Pro 9000, patterns 1 through 3 are printed
on the first sheet of paper. After this sheet is printed,
PAPER OUT
appears on the display and the red
PAPER OUT
light comes on.
6. Raise the paper set lever and remove the printed sheet. Even though the
Operate
light is flashing, it is safe to raise the paper set lever.
7. Load another sheet of paper. The next three patterns are printed.
8. Repeat steps 6 and 7 twice, until all 12 patterns have been printed.
9. Raise the paper set lever and remove the last printed sheet. Then lower
the lever and continue the alignment procedure in the next section.
Summary of Contents for Stylus Pro 9000
Page 1: ...EPSON Stylus Pro 9000 Series PRINTER GUIDE ...
Page 9: ... x x Contents ...
Page 89: ...4 14 4 14 Resolving Problems ...
Page 97: ...5 8 5 8 Specifications ...
