Item
Parameter
Explanation
Media
01 XXXXXXXXXX to
50 XXXXXXXXXX
Choose the media settings to use. The registered name appears in
XXXXXXXXXX.
Media Type
Displays the currently selected Media Type. This cannot be changed.
Media Width
Set the
Media Detection
items.
Pass Mode
Displays the currently selected Pass Mode. This can be changed.
Advanced Settings
You can change the
Advanced Settings
for the registered media
selected in
Media
.
See the following table for details on the setting content.
U
“Media Management items” on page 114
Print Adjustments
Automatic Adjustment
Perform
Automatic Adjustment
in the following cases.
❏
When registering media settings in the EMX file to the printer
❏
When changing
Advanced Settings
after saving media settings
❏
When the media type is the same but the width is different
If an error occurs when you perform Automatic Adjustment, or if you
notice banding or graininess in the print results, perform
Manual
Adjustment
.
See the following for more information.
U
“Optimizing Media Settings (Automatic Adjustment)” on page 61
Manual Adjustment
Media Feed Adjust-
ment
Manual (Standard)
Manual
(Measurement)
Print Head Alignment
Media Management
01 XXXXXXXXXX to 50 XXXXXXXXXX
U
“Media Management items” on page 114
Remaining Amount Management
Remaining Amount
Management
On
When
On
is selected, you can set
Remaining Amount
and
Remaining
Alert
. Setting each item to manage the remaining amount makes it
easier to know when it is time to replace the media.
When this is set to
On
, once you have loaded the media and selected
the registered media settings number, you will be prompted to enter
the media length (Remaining Amount).
Off
*
Remaining Amount
1.0 to 999.9 m
(50.0 m
*
)
(3.3 to 3280.5 feet
[164.0*])
Set the total length of the loaded media. You can set in 0.1 m
increments. The amount of media remaining is estimated based on the
length you set here and the length of the printout, and is displayed on
the Home screen.
Remaining Alert
1.0 to 15.0 m (5 m
*
)
(3.3 to 49.2 feet
[16.4*])
Set a value at which point a warning message is displayed to inform you
that the remaining amount of media is too low. You can set in 1 m
increments. Depending on settings such as
Media Back Feed after
Curing
, a media end error may occur when the remaining amount of
media is below approximately 1.6 m.
SC-R5000 Series/SC-R5000L Series User's Guide
Control Panel Menu
113
