Epson Mobilink TM-P60, Technical Reference Manual

Page: 59 / 148

Rev. B Troubleshooting 3-5
TM-P60 with Peeler Technical Reference Guide
3.6 Radio Field Intensity Check Mode
This mode prints the current radio field intensity on roll paper. This mode is useful to confirm
that the printer can communicate with an access point at the current location by radio.
1. Make sure the printer is turned off and the roll paper cover is closed properly.
2. Open the peeler cover.
3. While holding down the FEED button, turn on the printer using the POWER button.
4. Press the FEED button 2 times.
5. Close the peeler cover.
6. Follow the printed instructions.
7. Turn off the power.
3.6.1 Resetting the printer
Reset the printer’s LAN setting to be certain it is correct.
This mode is useful when you need to set the wireless LAN setting of a TM-P60 with Peeler
when the setting cannot by changed by an Access point, serial cable, or TMNetWinconfig. In this
case, reset the printer to change the printer to Ad-Hoc mode for communication without any
access point.
Note:
When you haven’t adjusted the printer’s wireless LAN setting, or you set up the printer with a serial
interface, you can omit the resetting. In this case, omit the resetting; then confirm the current setting.
The printer may beep when turned on. It is caused by the access point’s LAN setting not corresponding to
the printer’s setting. Ignore the beeping.
1. Open the peeler cover.
2. Turn on the printer's power while pressing down the FEED button.
3. Press the FEED button 6 times.
4. Close the peeler cover.
5. The printer prints the procedure for resetting. Follow the procedure. (Open the peeler cover,
press the FEED button one time, close the peeler cover.)
Then, the printer prints "Initialize" and cuts the paper, then starts resetting. Printer is rebooted
after the initialization.
Note:
This printer completes the initialization a few seconds.