Epson Mobilink TM-P60, Technical Reference Manual

Page: 31 / 148

Rev. B 2-5 Setup
TM-P60 with Peeler Technical Reference Guide
Setup Flow
You have to set up your printer to use it. And you can adjust some features by customizing
them. This section describes the setup.
The setup flow of preparing to use printer is below.
Note:
A printer may beep when turned on. It is caused by the Access point’s LAN setting not corresponding to
the printer. Ignore the beeping. (see “Beeping Types” on page 2- 2 for the beeping pattern.)
When you use OPOS (OCX driver from EPSON) or the Advanced Printer Driver, you need to install the
driver. When you use ESC/POS commands, you don’t have to install drivers.
The following sections describe the setup.
5. Complete setup
2. Adjust various settings (If you need to)
❏
DIP switches
❏
Memory switches
❏
Paper width (Adjust the spacer)
4. Driver setup
❏
OPOS
❏
APD
When you select
Direct control
method (ESC/
POS command,)
you don’t need
to install any
drivers.
1. Printer setup
❏
Switching issuing mode
❏
Install Roll Paper
❏
Install the battery pack or connect the printer to the AC adapter
3. Install to your wireless LAN by either method.
❏
Using utility (TMNet WinConfig)
•
with wireless LAN
•
with serial connection (RS 232C)
❏
Using browser
•
with wireless LAN