Epson EPL-N1200, Reference Manual

Page: 170 / 256

Using the printer driver:
Change the Density setting on the Printer SelecType menu in
the printer driver.
Using the Remote Control Panel utility:
Bring up the Remote Control Panel utility by typing
EPRCPO
at the DOS prompt; select the appropriate emulation from the
main Remote Control Panel window; click the
Printer Setup
button; then change the Density setting.
Using the SelecType mode:
For information on using SelecType, see Chapter 6.
Note:
Increasing the print density increases toner consumption. If you
select darker print, you may need to replace the imaging cartridge
more often.
Resetting the Printer
There are two ways to reset (return to a fixed set of conditions)
the printer.
Reset
Reset the settings for the emulation mode and interface you are
using now by holding down
Alt and Reset until Reset appears
on the display. You can reset the printer anytime a printout is
not being sent on the interface you are using.
Reset all
Reset the settings for all emulation modes and interfaces by
holding down
Alt and Reset until Reset All appears on the
display. You can also reset all emulation modes and interfaces
by turning off and turning on the printer.
Note:
Reset all clears all print jobs received from all interfaces, so be careful
not to disrupt someone else’s print job.
R
Skylark Rev.c
A5 size Chapter 7
96/05/15 Pass 1, DR
Troubleshooting and Maintenance 7-29