Epson DFX-9000, Service Manual

Page: 22 / 333

Epson DFX-9000 Revision B
Product Description Basic specifications 15
Approved joining of multipart form sheets
Figure 1-4. Spot gluing on both sides
Figure 1-5. Combination spot gluing and crimping
Figure 1-6. Crimping both sides
The thickness of the perforation part
Figure 1-7. The thickness of the perforation area
C A U T I O N
Don’t use continuous multipart forms that are joined with
metal staples, one sided crimping, tape-staples, or bar-
gluing.
L
es
s t
h
an
25
.4
m
m
(1
inch)
L
es
s t
h
an
25
.4
mm
(1
inc
h
)
Less
t
h
an 76
.2
mm (
3 inch)
The thickness of the crimped part when extended should be less than 0.9 mm.
L
es
s t
h
an
25
.4
mm
(1
inc
h
)
Les
s t
h
an
76
.2
mm
(3
inc
h
)
Printing Side
Non printing
Side
The thickness of the crimped part when extended should be less than 0.9 mm.
The any crimp deformation of the paper surface must be on the bottom, and not the
printing surface.
Less than 2mm
The thickness of the tenting at the perforation fold should
be 2 mm or less.