Endress+Hauser Solimotion FTR20, Operating Instructions Manual

Page: 8 / 60

Solimotion FTR20 Basic safety instructions
8 Hauser
2 Basic safety instructions
2�1 Requirements for personnel
The personnel for installation, commissioning, diagnostics and maintenance must meet the
following requirements:
• Trained, qualified specialists: Must be qualified for this specific role and task
• Authorized by the plant operator
• Familiar with national regulations
• Before starting work: Read and make sure you have understood the instructions in the
manual and supplementary documentation as well as the certificates (depending on the
application)
• Follow the instructions and comply with the general requirements
Operating personnel must meet the following requirements:
• Must be instructed and authorized according to the requirements of the task by the plant
operator
• Follow the instructions in this manual
2�2 Designated use
The device described in these Instructions is intended only for movement detection of bulk
products and the detection of changes of a mass flow. Depending on the version ordered, the
device can also measure potentially explosive, flammable, poisonous and oxidizing fluids.
To ensure that the device remains in proper condition for the operation time:
• Use the device only for fluids against which the process-wetted materials are adequately
resistant.
• Observe the limit values (→  55 ).
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Verification for borderline cases:
• For special fluids and fluids for cleaning, Hauser is glad to provide assistance
in verifying the corrosion resistance of fluid-wetted materials, but does not accept any
warranty or liability.
Possible burn hazard from touching surfaces!
• For elevated fluid temperature, ensure protection against contact to prevent burns.
The Solimotion FTR20 flow indicator is approved for use in hazardous areas.
Proceed in accordance with the safety instructions.
→  8