Endress+Hauser Solimotion FTR20, Operating Instructions Manual

Page: 49 / 60

Solimotion FTR20 Repair
Hauser 49
11 Repair
The flow indicator for bulk solids Solimotion FTR20 is not to be repaired on-site.
11�1 General notes
11�1�1 Repair policy
The Hauser repair policy provides that repairs to the modularly designed devices can
be carried out by Hauser Service or customers with corresponding training.
Spare parts are combined in useful kits and are accompanied by the associated replacement
instructions. For more information on service and spare parts, please contact Hauser
Service.
11.1.2 Repairing Ex-certified devices
When repairing Ex-certified devices, please also note the following:
• Ex-certified devices may be repaired only by properly trained personnel or Hauser
Service.
• Relevant standards, national regulations and safety instructions (XA) and certificates must
be observed.
• Only original Hauser spare parts may be used.
• When ordering spare parts, please note the device designation on the nameplate.
Parts may only be replaced with the same parts.
• Carry out repairs according to the instructions. Following a repair, the individual testing
prescribed for the device must be carried out.
• A certified device may be converted to another certified version by Hauser Service
only.
• All repairs and modifications must be documented.
11�1�3 Replacing the electronics or a device
After replacing the electronics or a device, a new calibration is required, since the settings are
saved in the electronic insert.
If you are still able to read out the settings before making the replacement, make note of them
(→  56 ) and reenter them after the replacement. If this is no longer possible, the device
has to be recalibrated (→  28 ).
The device variants with connector and extended ordering option "electronics encapsulated"
can only be repaired by the manufacturer.
Details about the available device variants can be viewed in the product configurator on
the Hauser homepage www.endress.com .