Endress+Hauser Liquiline System CA80TN, Operating Instructions Manual

Page: 117 / 162

Liquiline System CA80TN Diagnostics and troubleshooting
Hauser 117
No. Message Factory settings Tests or remedial action
S
1)
D
2)
F
3)
541 Parameter load ok M On Off Configuration successfully loaded
542 Parameter load fail M On Off Loading of configuration has failed
‣
Repeat.
543 Parameter load abort M On Off Configuration loading aborted
544 Parameter reset ok M On Off Factory default successful
545 Parameter reset fail M On Off Setting of device configuration to factory setting
has failed
565 Configuration M On Off Invalid configuration of sample preparation
system
1. In Setup / Sample preparation , check the
number of channels used, their operating
mode and type of installation.
2. Check the permitted combinations of
sample preparation and analyzers, see the
Operating Instructions for the sample
preparation system.
714 Filter mats change M On Off Filter mat change necessary
The limit value for operating hours has been
exceeded
‣
Replace the filter mats and reset the
operating hours counter in the Diagnostics
menu.
715 Calibration expired M On Off The validity of the last calibration has expired.
The date of the last calibration is too far in the
past. Measurement can still take place.
Possible reasons:
Manual intervention has prevented automatic
calibration
1. Calibrate analyzer manually.
2. Check device configuration.
716 Calibration expired S On Off Calibration has failed or is not reliable
Possible reasons:
Stability criteria are not met
1. Check the configuration and perform a
manual calibration again.
2. Contact Hauser Service.
717 Photometer defective F On On Photometer defective
Possible reasons:
• No lamp voltage
• No lamp power
‣
Contact Hauser Service.