Configuring and operating the system
131
User Manual
UM6C55C (P7000597)
Lorain Power System (AP6C55CA/CB)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
are required in screens where one wishes to modify the information and/or
carry out a function.
Note:
If the passwords are not enabled, as shown in the Enable
Authorization box of the above screen,
no
password level is active and
access to the System Manager CIP is opened at all levels to anyone that
knows the
IP
address. It is therefore important that once the initial
installation and start-up of the power system is completed, the end user
replaces the factory default or any temporary installation passwords by his
own passwords and enables these, then gives these passwords to his
internal personnel based on the required password level for each individual
as per the followings.
There are four levels of passwords for accessing the remote GUI of the
System Manager CIP. These are listed and described in the following table.
The highest password level is “Admin” and the lowest password level is
“Display”. All functions available to users with a given access level are
available to users with higher access levels.
Table 5.6 – Access password levels for the GUI of the System Manager CIP
Password
level
Factory default passwords
(see note)
For users with the following
responsibilities:
Admin
Type admin and press Enter
or click on the
button
Remote users requiring to enable or
disable the passwords or to modify
most of the parameters in the system.
Write
Type write and press Enter
or click on the
button
Remote users requiring to modify
some of the parameters in the
system.
Read
Type read and press Enter
or click on the
button
Remote users for viewing of the
information only.
Display
Type 0000 and press Enter
or click on the
button
Local users for viewing of the
information only.
Note:
A factory default password can be used to access System Manager
CIP remotely until one’s own password is programmed and enabled.
Enabling and disabling the passwords
Once all passwords have been set as desired, these can be enabled by clicking
on the
button in the upper box in screen 63. The
field and button in the box will change to
as shown in
the following screen.
Summary of Contents for Lorain CIP 48120 AP6C55CA
Page 2: ......
