1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10
IC200D
25/192
SSP2
Solar panel probe 2 temperature
SSdi
Solar panel differential
SPMP
Solar panel water pump status
SLrL
Solar panel valve status
9.18 READ-OUT OF THE TIME COUNTING TO THE NEXT DEFROST
dF FUNCTION
Label involved in dF function:
dF1
delay time to next defrost of the circuit 1
dF2
delay time to next defrost of the circuit 2
Enter the function menu :
1. Use the UP or DOWN keys to select
dF
2. Push
SET
key: the dF1 label is showed on the top display, the bottom display shows the time delay to
next defrost in minutes / seconds. The
icon is on.
3. Use the UP or DOWN keys to select dF1 or dF2.
To exit the Hour function push MENU key or wait the timeout
9.19 READ-OUT OF THE PROBES CONFIGURED TO CONTROL AN AUXILIARY
OUTPUT RELAY
uS FUNCTION
.
Label involved in
uS
function
:
uSt1
auxiliary 1 probe value
uSt2
auxiliary 2 probe value
Enter the function menu
1. Use the UP or DOWN keys to select uS.
2. Push
SET
key: the label
uSt1
(temperature probe) or
uSP1
(Pressure probe) is showed on bottom
display, the top display shows the the temperature or pressure value.
3. Use the UP or DOWN keys to select
uSt1
auxiliary 1 probe or
uSt2
auxiliary 2 probe.
4. To exit the Hour function push MENU key or wait the timeout.
9.20 HOW TO DISPLAY THE TEMPAERATURE OF THE INTERNAL TEMPERAURE
SENSOR OF THE REMOTE TERMINAL 1 OR 2
Inside the funcion menu it is possible to see the ambient temperature detected by the NTC sensor
FUNCTION trEM
to show the temperature of the remote panels
Identification label
trEM.
trE1
value of the NTC probe of the remote #1
trE2
value of the NTC probe of the remote #2
Select with
UP
or
DOWN
the
trEM
function
Push
SET
the trE1 or trE2 label is shown on the bottom display, the top display shows the probe value.
Use the UP or DOWN arrow to change beteween
trE1
or
trE2
read-out.
To exit to the normal display read-out push MENU or wait the time
– out time.
ATTENTION:
THE trEm function and the labels trE1 or trE2 appear only if the CF56 = =2 or 3 (remote panel 1
configuration) or if the parameter CF56 = 2 or 3 (remote panel 2 configuration).
9.21 ON BOARD CLOCK (OPTIONAL)
If giving power supply the bottom display shows “
rtC
” alternated with a temperature or pressure value, It is
necessary to set the internal clock.
After a power failure, clock back-up battery lasts maximum 3 or 4 days. After this period it is necessary to set
the clock again.
The internal clock is an option and it is not possible to update the instrument; it is necessary to order
the instrument already complete of this features.
