1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10
IC200D
191/192
external relay
Accuracy:
Out1..Out3: ±2% full scale
Note:
The electrical devices controlled by these
analogue outputs must be powered
separately with another transformer (do
not use the same secondary of the
controller's power) in order to prevent the
outputs from malfunctioning or being
damaged.
59.5 DIGITAL OUTPUTS
Type:
Relays with NO contacts
Number of outputs:
5: IC205D model
7: IC207D model
Maximum load:
5A(250Vac) SPST 5(2)A
Note:
Verify maximum current of the loads and
maximum current of the common line of
the relay (10A max).
There is double insulation between the
digital outputs and the low voltage of the
rest of the circuit.
Do not use different voltages for the
various groups of relays nor within each
group.
59.6 OPERATING AND STORAGE TEMPERATURE
Operating temperature:
-10°C ÷ 55°C
Storege temperature:
-30°C ÷ 85°C
Operating humidity:
20% ÷ 85% (not condensing)
60.
INSTALLATION
The device must not be installed in environments where the following situations are present:
Temperature and humidity outside the range stipulated in the data plate. Frequent and sudden
changes in temperature and/or humidity
Direct sunlight and weathering in general
High mechanical stress (vibrations and/or knocks)
Sulphur and ammonia gas, smoke and salt spray that can cause corrosion and/or oxidation
Presence of flammable or explosive gas
Dust
Devices that generate magnetic interference
Position the device inside the electrical panels, paying attention to the following:
the distance between the device and the electrical power components
the distance between the device and the power cables
sufficient passage for the cooling air
Always comply with the laws and regulations applicable in the country where the device is installed.
Always protect the device for it to always be accessible solely by authorised personnel.
In case of malfunctions, always contact the relative distributor for the device to be repaired.
