EMC-PARTNER 103514, User Manual

Page: 75 / 112

23.04.2012 E-MIG-OS-OS1-MIG0603OSI-E-Manual 75/112
13 Serial Remote Control
13.1 General
The MIG remote-control-option enables remote control of the MIG via the RS-232 serial port.
.
13.1.1 Technical Data of the RS 232C serial port
The V.24 serial port uses the data lines TxD and RxD for the information transfer.
Baudrate:
1200, 2400, 4800, 9600, 19200
Databits: 7, 8
Parity:
None , Even, Odd
Stop: 1 , 2
Protocol: None , RTS/CTS, XON/XOFF
End of sequence:
CR , LF, CR+LF
With the pinning below the remote control of a TRA2000 or MIG2000 generator is guaranteed.
Pinning Signal 9 pol SubD Signal 25 pol SubD
TxD Pin 3 TxD Pin 2
RxD Pin 2 RxD Pin 3
RTS Pin 7 RTS Pin 4
CTS Pin 8 CTS Pin 5
DCD Pin 1 DCD Pin 8
DSR Pin 6 DSR Pin 6
DTR Pin 4 DTR Pin 20
GND Pin 5 GND Pin 7
RI Pin 9 RI Pin 22
Standard Nullmodem
TxD 3 >>>>>>> RxD 3
RxD 2 >>>>>>> TxD 2
RTS + CTS 7 + 8 >>>>>>> DCD 8
DCD 1 >>>>>>> RTS + CTS 4 + 5
DSR + DTR 6 + 4 >>>>>>> DSR + DTR 6 + 20
GND 5 >>>>>>> GND 7
3-Wire Nullmodem
TxD 3 >>>>>>> RxD 3
RxD 2 >>>>>>> TxD 2
RTS+CTS+DCD 7 + 8 + 1 RTS+CTS+DCD 4 + 5 + 8
DSR + DTR 6 + 4 DSR + DTR 6 + 20
GND 5 >>>>>>> GND 7
EMCP 25/9 pole cable
TxD 3 >>>>>>> RxD 3
RxD 2 >>>>>>> TxD 2
RTS 7 >>>>>>> DCD 8
CTS + DSR 8 + 6 >>>>>>> DTR 20
DCD 1 >>>>>>> RTS 4
DTR 4 >>>>>>> CTS + DSR 5 + 6
GND 5 >>>>>>> GND 7
Min. wiring for remote
TxD 3 >>>>>>> RxD 3
control cable
RxD 2 >>>>>>> TxD 2
RTS + CTS 7 + 8
GND 5 >>>>>>> GND 7
Change Communication Parameters:
To change the communication values on the generator go to the REM (Remote) menu:
after power-on push
Æ
MAIN
Æ
MENU
Æ
MENU
Æ
REM. There you can change the values.
Recommended parameters are:
19200 Baud, CR, no protocol, 8 databit, 1 stopbit, no parity