_________________________________________________________________________________
_________________________________________________________________________________
Universal Network Terminal TAU-32M.IP 79
5.1.1.11
ACS submenu – TR-069 monitoring and management protocol configuration
TR-069 Monitoring and Management Protocol Settings (TR-069 Settings):
–
Enable
– when checked, enable device management via TR-069 protocol;
–
ACS address
– ACS server address. The address shall be entered as
http://<address>:<port> (<address>
–
IP-address or domain name of ACS-server,
<port>
– the port of ACS server, 10301 by default);
–
Periodic inform enable
– when checked, integrated TR-069 client will periodically poll ACS server at
intervals equal to
'Periodic inform interval'
value in seconds. Goal of the polling is to identify possible
changes in the device configuration.
–
Periodic inform interval –
ACS server polling interval.
–
Username
– username used by client to access the ACS server;
–
Password
– password used by client to access the ACS server;
–
ConnectionRequest username
– username used by ACS server to access the TR-069 client. Server sends
ConnectionRequest notifications;
–
ConnectionRequest username
– password used by ACS server to access the TR-069 client. Server sends
ConnectionRequest notifications.
If there is a NAT (
network address translation
) between the client and ACS server, ACS server may not be able
to establish the connection to client without specific technologies intended to prevent such situations. These
technologies allow the client to identify its so called public address (NAT address or in other words external address
of a gateway, that covers the client.) When public address is identified, the client reports it to the server that uses
this public address for establishing connection to the client in the future.
–
NAT mode
– TR-069 client operation mode in the presence of NAT;
identifies the method, that will be
used by client for obtaining
its public address information. Available modes:
STUN
– use STUN protocol for public address identification. When choosing STUN client operation
mode, you should define the following settings: