_________________________________________________________________________________
_________________________________________________________________________________
28
Universal Network Terminal TAU-32M.IP
3.1.3
Electrostatic Discharge Safety Measures
For the avoidance of failures caused by electrostatic discharge, we strongly recommend to:
1.
Put on esd belt, shoes or wrist strap to prevent electrostatic charge accumulation (for the wrist strap,
ensure that it fits snugly to the skin) and to ground the cable before starting to work with the equipment.
3.2
TAU-32M.IP Installation
Check the device for visible mechanical damage before installing and turning it on. In case of any damage, stop
the installation, fill in the corresponding document, and contact your supplier.
If the device has been exposed to low temperatures for a long time before installation, leave it for 2 hours at
ambient temperature prior to operation. If the device has been exposed to high humidity for a long time, leave it for
at least 12 hours in normal conditions prior to turning it on.
Mount the device. The device is intended to be installed into 19" rack using the mounting set or mounted on
the horizontally oriented perforated shelf.
If the device is being installed into a closed non-ventilated cabinet with volume less than 180l per
device, device performance will not exceed 0.8 Erlang per subscriber unit.
Ground the case of the device after installation. This should be done prior to connecting the device to the
power supply. Use an insulated stranded wire to ground the case. The device grounding and the earthing wire
section should comply with Electric Installation Code. The earth bonding point is located at the right bottom corner
of the rear panel, see Fig. 88.